CV1 10 P 0 5，美国伊顿比例阀

A typical circuit for a single stage

feedback type valve in an open (outer)

loop application is shown in Figure 1. A

24VDC power supply is connected to

pins bdz32 (+) and bdz30 (–). An enable

switch connected between bdz32 and

pin z2a is required. The valve is

connected according to the circuit

diagram. A (+) or (–) 10V at 5mA

reference is provided for command

voltage control. When wired as shown in

the diagram, the control pots should be

2000 ohms or greater. If the pot is to be

connected across the (+) or (–) pins z2

and b2, the minimum pot size should be4000 ohms.

对于单级的典型电路

在一个开放的反馈式阀（外）

环应用在图1 A中所示

24VDC电源连接到

销bdz32（+）和bdz30（ - ）。使能

交换机相连bdz32之间

销Z2A是必需的。阀门

根据该电路连接的

图。 A（+）或（ - ）10V为5mA

参考提供了命令

电压控制。当有线如图

图中，对照盆中应

2000欧姆或更大。如果锅是要

跨越（+）连接或（ - ）引脚Z2

和b2，小锅大小应4000欧姆。

CV1 10 P 0 5，美国伊顿比例阀